33
Transmitter description - Function elds and entry lockout
Warning notices
Batt. must
be re-
charged!!
transmitter operating volt-
age is too low
BIND. N/A
OK
"Bind not available"
A receiver has not yet been
bound to the currently ac-
tive model memory. A brief
tap on the SET key will
cause a direct jump to the
appropriate option.
CAN‘T
RECEIVE
DATA
No bound receiver in
range
Attention!
Switch-OFF
the Receiver first!
This warning appears if
you try to change mod-
els in the »Model select«
menu with the receiver of
the previously active mod-
el still switched on.
OFFON
Please select
RF on/off?
Only for a receiver that has
already been bound:
Please select RF "on" or
"off"?
Warning notices
RF
MUST BE
OFF
OK
Prompt to switch off RF
transmission
(A bound receiver can only
be replaced by another
receiver when RF
transmis-
sion is switched off.)
Fail Safe
setup
t.b.d.
Failsafe has not yet been
activated
Throttle
too
high!
Gas stick by winged mod-
els or throttle stick or lim-
iter by helicopter too high
No
pupil
signal
Connection between
teacher and pupil transmit-
ter is interrupted
SD-CARD
INSERT
OK
No SD or SDHC memory
card in the card slot or
card is not legible
• The transmitter has not been operated within the
time period specifi ed by the "Stick warning" line of
the »Basic settings« menu, see page 279. The
message …
Power on warning
is active!
• ..., The “WARNING” LED to the right of the ON
/ OFF switch will blink and acoustic signals will
sound. If the transmitter is now still not actuated
switches
• If battery voltage is too low, a model switch is
blocked for reasons of safety. An appropriate mes-
sage will appear in the screen:
not possible now
voltage too low
• Is the “wireless teacher/pupil connection” that was
active when the transmitter was last used to be
continued, ACT or switched off INH?
Please select
Trainer link?
ACT INH
Please select
Trainer link?
ACT INH
To Next Page
Loading...
