160
Program description - Phase assignment
Phase assignment
Setting up flight phases
Use the selection keys of the left or right touch pad to
scroll to the »Phase assignment« menu option in the
multi-function menu:
Servo adjustment
Stick mode
Control adjust
Dual Rate / Expo
Channel 1 curve
Switch display
Base setup model
Model type
Control switch
Logical switch
Phase settings
Phase assignment
Servo adjustment
Stick mode
Control adjust
Dual Rate / Expo
Channel 1 curve
Switch display
Base setup model
Helicopter type
Control switch
Logical switch
Phase settings
Phase assignment
Open this menu option with a tap on the centre SET
key of the right touch pad.
P H A S E ASSIGNMENT
prior
C
1 Normal
combi
A
B D E F
Note:
A phase name appears to the right of the
phase number at the bottom right of the
display only if you have assigned the name
beforehand on the »Phase settings« menu.
In the »Phase settings« menu, described above
separately for fixed-wing and helicopter models,
you will have set up names for your phases. On this
menu – which is identical for both model types – you
must now specify the switches or switch combina-
tions that you want to use to trigger each phase. One
exception for helicopter menu: one of the two auto-
rotation switches must be set on the menu »Basic
settings, model« (page 100).
Please note the following priorities:
• If no flight phase switches nor these names have
been assigned in this menu, the model is in flight
phase "1". Accordingly, by the time you start pro-
gramming flight phases, you should therefore have
already given this flight phase the phase name
"Normal".
• Independent of the phases with allocated switch
settings made in this menu, the autorotation phase
(only present for the "Helicopter" model type and
to be assigned a switch in the »Basic settings,
model« menu) always (!) takes precedence. Ac-
cordingly, as soon as the auto-rotation switch in
question is activated, the following warning ap-
pears:
P H A S E ASSIGNMENT
prior
C
1 Normal
Kombination
A
B D E F
Autorot
• Phase switch "A" is given priority over all subse-
quent switch positions, from "B" to "F"
• Phase switch "B" is given priority over all subse-
quent switch positions, from "C" to "F"
• 3-way switches should always be assigned from
the middle position.
Therefore use switch "A" and/or switch "B" only if you
wish to change from any other flight phase – apart
from the helicopter's autorotation phase – directly into
the phase that is assigned to this switch.
Programming ight phase switches
Once you have configured your desired switch posi-
tion, "A" to "F", using the selection keys on the left or
right touch pad, a switch (whether a "normal" switch
or an expanded switch) is then assigned as described
in the section "Assigning transmitter controls, switch-
es and control switches" (page 60).
The order in which assignment is made is irrelevant:
you must ensure only that you assign what are, for
you, the "correct" switches. (In the helicopter program,
for example, you should also take care to ensure you
do not use this menu to re-assign any auto-rotation
switch already assigned on the »Basic settings,
model« menu.)
Example: 4 ight phases with phase priority
P H A S E ASSIGNMENT
prior
C
1 Normal
combi
A
B D E F
2 6 7
Assigning ight phases to switch positions
Now that names have been assigned to the flight
phases (1 … max. 8) in the »Phase settings« menu
and also programmed switches in this menu, but …
at the bottom right of the display screen, you only see
<1 Normal > – regardless of the positions the switches
are in!?
Use the selection keys on the left or right touch pad to
move the marker frame down and to the right and then
briefly tap the centre SET key of the right touch pad:
To Next Page
Loading...
