GRAUPNER mc-32

161
Program description - Phase assignment
P H A S E ASSIGNMENT
prior
C
1Normal
combi
A
B D E F
2 6 7
Now close one (or more, as required) of the switches
that you have assigned, and assign one of the flight
phase names from the list you selected beforehand
on the »Phase settings« menu to this switch position
or combination.
Here, for example, we assign the "Launch" phase to
the closed ("I") priority switch "A" …
P H A S E ASSIGNMENT
prior
C
2 Launch
combi
A
B D E F
2I 6 7
… if, for example, we wish to switch to this phase
regardless of the "C" … "F" switch positions, because
the same switch activates an electric motor, etc.
Use the same approach to set the other switches or
combinations of switches.
Theoretically – for the situation where all three are
closed – you could use the three single switches
shown in the example to define an additional fifth
flight phase on the »Phase settings« menu. Howev-
er, since this example assumes just four flight phases,
you can leave the default phase name as «1 Normal»
for this switch position.
Leave this menu in the familiar way, with a tap on the
centre ESC key of the left touch pad.
Tips:
•
If you have named more phases than you
currently have switches dened for then
this is not really problematic. You can
repeat and change your switch assignment as you
wish at any point in time. And you can also name
additional phases at any time and then assign
switches to them.
• When assigning switches, check whether the
switches are already otherwise assigned to ensure
that you avoid duplicate assignments.
Important notice:
Before a phase switch is assigned,
the model settings configured are
now to be found in the flight phase
«1 Normal», i. e. all flight phase-dependent
menus are reset to the standard
configurations for all other flight phases.
To avoid having to start from scratch in
every flight phase, you can copy over these
standard settings by using the command
"Copy flight phase" on the "Copy / Erase"
menu to replace them with flight data
obtained from the «Normal» flight phase.
You then need only to make further flight
phase-specific changes to the settings.