53
Reciver initialization
When also the default set enclosed receiver GR-12L
only the red LED lights up for about 3 seconds, then
goes out for about 3 seconds and starts to glow red
constant after this break.
Release the button once the red LED goes out.
If the reset is performed with an unbound receiver, a
binding process can be initiated immediately after-
wards.
Please note the following:
A receiver RESET will cause ALL
receiver settings, except for binding
information, to return to their factory
settings.
Therefore if a RESET is triggered uninten-
tionally, any custom settings that had been
present in the receiver before the reset will
have to be established again by way of the
Telemetry menu.
A deliberate RESET is recommended, es-
pecially if a receiver is to be "transferred"
into another model. This is a rather simple
method to eliminate settings which are no
longer applicable.
Receiver firmware updates
Receiver firmware updates are made by way of the
connector located on the side of the receiver and
the help of a PC running under Windows XP, Vista or
Windows 7 or 8. The included USB interface cable
No.7168.6 along with adapter cable, No.7168.6A are
needed to run an update. The programs and files also
needed can be found as a complete packet in Internet
on the Graupner website at www.graupner.de under
the downloads for the respective product.
Download this software package, such as the en-
trance to the section “Update the transmitter software”
on page 50 describes from the related internet page
and unzip it on your PC or laptop. For details, please
refer to the same internet page detailed instructions.
Note:
After registering your receiver at
https://www.graupner.de/de/service/
produktregistrierung.aspx
you will automatically receive notication of future
updates per email.
As you enter the section “Update the transmitter
software” on page 50, after having downloaded from
the Internet and unzipped on the PC or laptop the
software packet, among other things it is included the
PC program “Firmware_Upgrade_grStudio” .
You may even have already installed this program on
your PC or laptop.
With the menu item “Receiver settings” this PC
program “Firmware_Upgrade_grStudio” it is always
possible to save all the settings programmed in a
receiver to a file on the PC or laptop, so you also
can transfer back to the receiver these if necessary.
The otherwise possibly necessary reprogramming
of a receiver via the menu “Telemetry” is therefore
unnecessary.
For this program the default to mc-32 HoTT
transmitter set (No. 33032) is included USB interface
(No. 7168.6) and also the supplied interface cable
(No. 7168.S) are needed.
For details, please refer to the place on the internet at
the same place detailed instructions.
Secure receiver settings
To Next Page
Loading...
