GRAUPNER mc-32

284
Program description - Code lock
Code lock
Locking the multifunction menu
Use the selection keys of the left or right touch pad to
scroll to the menu option »Code lock display« menu
option in the multi-function menu
Profi trim
Trim memory
Telemetry Channel sequence
Multichannel Ring limiter
Mp3 player
Basic settings
Servo display Servo test
Code lock Info display
… in the multi-function menu. Tap briefly on the cen-
tre SET key of the right touch pad to open this menu
option:
CODE LOCK
Desired (new) access code:
(_ )
SET
321 3 4
Access to the multifunction menu can be locked
against unauthorized use by a four-digit secret code
comprised of the numbers 1 to 4. This code lock is
entered by way of the selection keys of the left touch
pad according to the scheme shown in the display, for
example:
CODE LOCK
Desired (new) access code:
(123_)
CLR
321 3 4
As soon as another tap of a left touch pad selection
key occurs after the fourth number has been entered,
the message shown below will appear in the display:
CODE LOCK
Bitte Geheimzasccess code:
(1234)
CLR3
21 3 4
Memorise access
code carefully
A brief tap on the centre ESC key of the left touch
pad will conrm the entered secret code and exit the
menu.
On the contrary, a brief tap on the centre SET key of
the right touch pad will confirm the currently active
CLR field at the bottom right of the display and thus
erase the entered digits.
Make note of the secret code and keep it
safe. Otherwise, the transmitter must be
sent in to Graupner service for decoding.
The lock becomes active the next time the transmitter
is switched on. However, the control remains ready
for operation. However, a call-up of the multi-function
menu, and thus also a model change, can no longer
be accomplished without entering the correct number
combination.
CODE LOCK
Desired (new) access code:
(_ )
SET
321 3 4
A renewed attempt following an incorrect entry is only
possible after the lapse of a time-out.
CODE LOCK
Bitte Geheimzacccess code:
(4321)
CLR3
21 3 4
Input error
Time lock
Deletion of the secret code
If the secret code is to be erased later on, tap twice
on the centre SET key of the right touch pad right
after calling up this menu option.
CODE LOCK
Desired (new) access code:
(1234)
CLR3
21 3 4
The first activation of the centre SET key of the right
touch pad will erase the secret code (CLR):
CODE LOCK
Desired (new) access code:
(_ )
SET
321 3 4
and the second activation will confirm the empty entry
field (SET). The message shown will appear in the
display: