121
Program description - Control adjust | Winged models
changed with the selection keys of the right touch pad.
0%
+111%I5
I6
I7
I8
TYP
+111%
0.0 0.0
– travel + –time+
0%
+100%
+100%
0.0 0.0
0%
+100%
+100%
0.0 0.0
0%
+100%
+100%
0.0 0.0
GL
GL
GL
fr
fr
fr
---
---
---
Offset
GL
Normal
7
8
0%
+88%I5
I6
I7
I8
TYP
+100%
0.0 0.0
– travel + –time+
0%
+100%
+100%
0.0 0.0
0%
+100%
+100%
0.0 0.0
0%
+100%
+100%
0.0 0.0
GL
GL
GL
fr
fr
fr
---
---
---
Offset
GL
Normal
7
8
Another brief tap on the centre SET key of the right
touch pad will complete the entry.
Negative and positive parameter values are possible
in order to appropriately adapt the control's direction
or effect.
A simultaneous tap on the or keys of the
right touch pad (CLEAR) will reset the changed pa-
rameter displayed in inverse video back to "+100 %".
Important:
In contrast to servo travel settings, changing the
control travel setting affects all "downstream" mixer
and coupling inputs, i. e. any and all servos actuated
by the given transmitter control.
Column 6, "–time+"
Each of the function inputs 5 … 16 can be assigned
a symmetrical or asymmetric time delay of between 0
and 9.9 s.
To set a symmetric, i. e. control-side independent,
time delay, the respective operating element (trans-
mitter control or switch) is to be put into a position in
which the time setting is covered on both sides by the
marker frame.
0%
+111%I5
I6
I7
I8
TYP
+111%
0.0 0.0
– travel + –time+
0%
+100%
+100%
0.0 0.0
0%
+100%
+100%
0.0 0.0
0%
+100%
+100%
0.0 0.0
GL
GL
GL
fr
fr
fr
---
---
---
Offset
GL
Normal
7
8
To set an asymmetric time delay, move the given
transmitter control (proportional control or switch)
as necessary to the side to be set such that only the
value to be changed is covered.
0%
+111%I5
I6
I7
I8
TYP
+111%
0.0 0.0
– travel + –time+
0%
+100%
+100%
0.0 0.0
0%
+100%
+100%
0.0 0.0
0%
+100%
+100%
0.0 0.0
GL
GL
GL
fr
fr
fr
---
---
---
Offset
GL
Normal
7
8
Briefly tap the centre SET key of the right touch pad
to activate value setting. The value field will be dis-
played in inverse video. Use the selection keys of the
right touch pad to change the value in a range of 0.0
to 9.9 s.
Another brief tap on the centre SET key of the right
touch pad will complete the entry.
A simultaneous tap on the or keys of the
right touch pad (CLEAR) will reset the changed pa-
rameter displayed in inverse video back to 0.0.
Notes:
Suggestions for the structure of temporal
sequences, see “Controlling timed sequenc-
es” on page 318.
To Next Page
Loading...
