201
Program description - Helicopter mixer
The adjacent sketch illustrates the effect for a 100 %
setting. The cross-hatched area of travel is curtailed
and appears as a "dead
zone".
If this function is used,
"Dual Rate" should be
set to 100 % and Dual
Rate values above 100 %
should also not be used. If
not, and you set a swash-
plate limit of 100 %, for
example, then swashplate
movement will be restricted even if roll and pitch-axis
commands are given separately.
Setting range: 100 … 149 % and "off".
To Next Page
Loading...
