279
Program description - Basic settings
Pre-set DSC Output
PPM10
SEL
Top LCD contrast
0
Bottom LCD contrast
0
GENERAL BASIC SETTINGS
Pre-set Pitch min.
rear
Now display contrast can be adjusted in the value
fi eld displayed in inverse video within a range of ±20
by using the selection keys of the right touch pad.
Pre-set DSC Output
PPM10
SEL
Top LCD contrast
0
Bottom LCD contrast
-15
GENERAL BASIC SETTINGS
Pre-set Pitch min.
rear
Pre-set DSC Output
PPM10
SEL
Top LCD contrast
0
Bottom LCD contrast
+15
GENERAL BASIC SETTINGS
Pre-set Pitch min.
rear
Simultaneously tapping the or selection keys
of the right touch pad (CLEAR) will reset the inverse
video fi eld back to "0".
Display light
This line determines how long the transmitter dis-
play's backlight illumination is to remain on after
switching the transmitter on or after the last activation
of a transmitter operating element.
Available options are “unlim(ited)”, “30 s”, “60 s”,
“120 s” and “off”.
A simultaneous tap on the or selection keys
of the right touch pad (CLEAR) will reset the inverse
video fi eld to "unlimited".
Power on/off beep
A power on/off beep for the transmitter can be
switched on ("yes") and off ("no") in this line.
A simultaneous tap on the or selection keys
of the right touch pad (CLEAR) will switch this option
shown in inverse video back to "yes".
Battery type
SEL
Bottom LCD contrast 0
Battery type
Li-Io
Display light
unlim.
Power-on/off beep yes
GENERAL BASIC SETTINGS
This line specifi es whether transmitter power is pro-
vided by a four-cell NiMH battery or a single-cell LiPo
battery. As a consequence of this setting, the next
line will offer a suitable voltage range for the "Battery
warning" threshold.
A simultaneous tap on the or selection keys
of the right touch pad (CLEAR) will switch this option
shown in inverse video back to "Lith.".
Battery warning threshold
SEL
Battery type
Li-Io
Display light
unlim.
Power-on/off beep yes
GENERAL BASIC SETTINGS
Battery warning
3.60V
You can arbitrarily specify the warning threshold for
the display …
Batt. must
be re-
charged!!
… – contingent on the battery type selection in the
line above – in increments of 0.01 volt between 4.50
and 5.50 V (NimH battery) or 3.40 and 4.20 V (LiIo/
LiPo battery). Make sure that you do not enter a value
which is too low, so that you still have suffi cient time
to safely land your model in the event of a battery
warning.
A simultaneous tap on the or selection keys
of the right touch pad (CLEAR) will switch the fi eld
shown in inverse video back to its factory setting,
4.70 V (NiMh) or 3.60 V (Lith.).
Power-on warning
SEL
Battery type
Li-Io
Power-on/off beep yes
GENERAL BASIC SETTINGS
Battery warning
3.60V
Stick warning
unlim
In this line you can determine how long the transmit-
ter should wait after the last actuation of an operating
element until the activation of an optical and acoustic
power-on warning before the transmitter switches off
automatically one minute later.
The values "unlim(ited)", "30 s" and 1, 5, 10, 20, 30
and 60 minutes are optional selections.
A simultaneous tap on the or selection keys
of the right touch pad (CLEAR) will reset the inverse
video fi eld to "unlimited".
To Next Page
Loading...
