GRAUPNER mc-32

287
Program description - Info display
Time
RFID
Firmware Version
date
time
SD-CARD
1.234
ABCDEF12
2011/11/11(Fr )
11:22:33s
1943MB
If necessary, select this line with the selection keys of
the left or right touch pad and, as applicable, the min-
ute field. After activation of the respective value field
by a tap on the centre SET key of the right touch pad,
the hour or minute can be adjusted with the selection
keys of the right touch pad. Another tap on the centre
SET key of the right touch pad will close the given
entry.
In contrast, the seconds display cannot be set direct-
ly; it can only be restarted at "00" with a brief tap on
the centre SET key of the right touch pad.
Note:
•
If the transmitter is connected to a PC ,
the date and time can also be set through
the PC program provided for the
respective product via the Internet page at
www.graupner.de.
• The date and time are protected against data
loss due to power failure by a buffer battery for
situations like a battery change, see page 20.
SD card
RFID
Firmware Version
date
time
SD-CARD
1.234
ABCDEF12
2011/11/11(Fr )
11:22:33s
1943MB
In this line the memory capacity of a memory card in-
serted in the transmitter, if applicable, is shown in MB.
Depending on the memory capacity of the inserted
micro SD or micro SDHC memory card, it may take
several minutes until the correct value is shown after
switching on the transmitter.
available
Firmware Version
date
time
SD-CARD
1.234
2011/11/11(Fr )
11:22:33s
1943MB
available
1933MB
Display of the available storage space in MB.
As mentioned before, display of the available storage
space – depending on the capacity of the inserted
memory card – does not appear until some time has
passed after switching on the transmitter.
The display of the available storage space in rela-
tion to the total memory capacity is shown in the line
below:
date
time
SD-CARD
2011/11/11(Fr )
11:22:33s
1943MB
available
1933MB
99%
As mentioned before, display of the available storage
space – depending on the capacity of the inserted
memory card – does not appear until some time has
passed after switching on the transmitter.