72
Program description - Loading a new memory location
Model name
Stick mode
1
n/a
BASIC SETTINGS MODEL
Info
n/a
n/a
Module
bind
HoTT
SEL
If this setting is desired as a default for future models,
the setting can also be entered into the »General
basic settings« menu, page 276:
Owners name
Pre-set stick mode
Pre-set DSC Output
1
GENERAL BASIC SETTINGS
PPM10
SEL
Pre-set modulation
HoTT
It should be noted here once again that, in the interest
of greatest flexibility in combination with the prevention
of unintentional operating errors, no controls are preas-
signed to control channels 5 … 16 by default.
This means that, in the system's delivered
state, only servos attached to receiver
outputs 1 … 4 can typically be operated by
the two sticks and that any servos attached to
receiver connectors 5 … 16 (max) will remain in
their middle positions.
Firmware version V1102 and lower
A newly initialized helicopter model is also able to
more-or-less move servo 6 – depending on the posi-
tion of the right-side proportional rotary slider, which
is the default throttle limiter control.
Firmware version V1102 and higher
A newly initialized helicopter model is also able to
more-or-less move servo 6.
With either model type, this situation will only change
after appropriate assignments have been made in the
»Control adjust« menu.
On the other hand, if a newly initialized model mem-
ory is to be put into operation then it MUST first be
appropriately "connected" with one or more receivers
before the servos attached to the receiver/s can be
operated. More about this can be found in the section
"Binding" on page 118 or 122.
A fundamental description of programming steps for
a winged aircraft model can be found in the program-
ming examples section beginning on 288, or for heli-
copter models beginning on page 328.
The menu descriptions below are arranged in the
sequence individual menus are listed in the multi-
function list.
To Next Page
Loading...
