3-13
Parameters
None
Description
Use the encrypt enable command to encrypt downstream data.
Use the undo encrypt enable command to disable stream encryption.
By default, encryption is enabled for downstream data.
Examples
# Enable downstream data encryption.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] encrypt enable
encrypt key
Syntax
encrypt key key-value
undo encrypt key
View
ONU port view
Default Level
2: System level
Parameters
key-value: Encryption key, a string of up to 16 characters.
Description
Use the encrypt key command to configure the encryption key.
Use the undo encrypt command to restore the default encryption key.
This command takes effect on H3C ONUs only.
Currently, the encrypt key command is not supported.
Examples
# Configure the encryption key as test.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] encrypt key test
This operation is not supported in current version!
forward-error-correction enable
Syntax
forward-error-correction enable
To Next Page
Loading...
Need help?
General
