H3C S7500E Series

18-3
[Sysname-port-group-manual-1] group-member gigabitethernet 2/0/1 to gigabitethernet 2/0/6
[Sysname-port-group-manual-1] qinq enable
qinq ethernet-type customer-tag
Syntax
qinq ethernet-type customer-tag hex-value
undo qinq ethernet-type customer-tag
View
System view
Default Level
2: System level
Parameters
customer-tag: Indicates the TPID value in the CVLAN tag.
hex-value: Hexadecimal protocol type value, in the range of 0x0001 to 0xFFFF. However, do not set it
to any of the protocol type values listed in
Table 18-1..
Table 18-1 Common protocol type values
Protocol type Value
ARP 0x0806
PUP 0x0200
RARP 0x8035
IP 0x0800
IPv6 0x86DD
PPPoE 0x8863/0x8864
MPLS 0x8847/0x8848
IPX/SPX 0x8137
IS-IS 0x8000
LACP 0x8809
802.1X 0x888E
Cluster 0x88A7
Reserved 0xFFFD/0xFFFE/0xFFFF
Description
Use the qinq ethernet-type customer-tag command to configure the TPID value in CVLAN tags.