H3C S7500E Series Command Reference

2-21
Parameters
oui-value: OUI (Organizationally Unique Identifier) of the ONU.
version-value: OAM (Operation, Administration and Maintenance) version number of the ONU.
&<1-9>: Indicates that you can specify up to 9 OUI values/OAM version numbers.
slot-number: Slot number of the EPON card.
Description
Use the epon-parameter ouilist command to configure the OUI and extended OAM version number
of the ONU in the specified slot.
Use the undo epon-parameter ouilist command to cancel the configuration.
By default, the OUI and extended OAM version number are 111111 and 1 respectively. After this
configuration, an H3C ONU attached to an OLT goes online after being bound with the specified ONU
port (The OUI and extended OAM version number for an H3C ONU are 111111 and 1 respectively).
Note the following:
 Entries with the same OUIs and extended OAM version numbers cannot be not configured at the
same time on one EPON card.
 When the OUI and extended OAM version number list of an EPON card changes (when a list is
configured or canceled), all the ONUs under the EPON card will reregister.
Related commands: display epon-parameter.
Examples
# Configure the OUI and extended OAM version number of the ONU connected to the EPON card in
slot 3.
<Sysname> system-view
[Sysname] ftth
[Sysname-ftth] epon-parameter ouilist oui 111111 oam-version 2 slot 3
fiber-backup group
Syntax
fiber-backup group group-number
undo fiber-backup group group-number
View
FTTH view
Default Level
2: System level
Parameters
group-number: Fiber backup group number, in the range 1 to 80.
Description
Use the fiber-backup group command to create a fiber backup group and enter fiber backup group
view or directly enter fiber backup group view if the fiber backup group already exists.
Use the undo fiber-backup group command to delete a fiber backup group.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English