21-2
Table 21-1 display service-loopback group command output description
Field Description
Service Group ID Service loopback group ID
Quote Number Reference count of the service loopback group
Service Type
Service type of the service loopback group, which can be one of the following:
Multicast tunnel, supporting multicast tunnel traffic
Tunnel, supporting unicast tunnel traffic
Member Member ports of the service loopback group
Status Port state, which can be selected or unselected
port service-loopback group
Syntax
port service-loopback group number
undo port service-loopback group
View
Layer 2 Ethernet interface view
Default Level
2: System level
Parameters
number: Service loopback group ID. The value range for the number argument is 1 to 1024.
Description
Use the port service-loopback group command to assign the current port to the specified service
loopback group.
Use the undo port service-loopback group command to remove the current port from the specified
service loopback group.
By default, a port does not belong to any service loopback group.
Note that:
To assign multiple ports to a service loopback group, run this command on multiple ports
separately.
You cannot remove the last member port of a referenced service loopback group.
To Next Page
Loading...
Need help?
General
