H3C S7500E Series

3-29
Examples
# Configure UNI 1 to operate in the auto-negotiation mode.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] uni 1 duplex auto
uni flow-control
Syntax
uni uni-number flow-control
undo uni uni-number flow-control
View
ONU port view
Default Level
2: System level
Parameters
uni-number: UNI number, in the range 1 to the number of UNI ports of the current ONU. The number of
UNIs can be up to 80.
Description
Use the uni flow control command to enable flow control for a UNI.
Use the undo uni flow-control command to disable flow control.
By default, flow control is disabled on a UNI.
Examples
# Enable flow control for UNI 1.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] uni 1 flow-control
uni igmp-snooping fast-leave
Syntax
uni uni-number igmp-snooping fast-leave
undo uni uni-number igmp-snooping fast-leave
View
ONU port view
Default Level
2: System level
Parameters
uni-number: UNI number, in the range 1 to the number of UNI ports of the current ONU. The number of
UNIs can be up to 80.
Description
Use the uni igmp-snooping fast-leave command to enable fast leave on the UNI.