20-18
tx: Specifies the Tx mode. A port in this mode sends LLDPDUs only.
txrx: Specifies the TxRx mode. A port in this mode sends and receives LLDPDUs.
Description
Use the lldp admin-status command to specify the LLDP operating mode for a port or all the ports in a
port group.
Use the undo lldp admin-status command to restore the default LLDP operating mode.
The default LLDP operating mode is TxRx.
Examples
# Configure the LLDP operating mode as Rx for GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] lldp admin-status rx
lldp check-change-interval
Syntax
lldp check-change-interval interval
undo lldp check-change-interval
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
Parameters
interval: LLDP polling interval to be set, in the range 1 to 30 (in seconds).
Description
Use the lldp check-change-interval command to enable LLDP polling and set the polling interval.
Use the undo lldp check-change-interval command to restore the default.
By default, LLDP polling is disabled.
Examples
# Enable LLDP polling on GigabitEthernet 2/0/1, setting the polling interval to 30 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] lldp check-change-interval 30
lldp compliance admin-status cdp
Syntax
lldp compliance admin-status cdp { disable | txrx }
View
Layer 2 Ethernet interface view, port group view
To Next Page
Loading...
Need help?
General
