17-2
Related commands: reset garp statistics.
Examples
# Display GARP statistics on ports GigabitEthernet 2/0/1 and GigabitEthernet 2/0/2.
<Sysname> display garp statistics interface GigabitEthernet 2/0/1 to GigabitEthernet 2/0/2
GARP statistics on port GigabitEthernet2/0/1
Number of GVRP Frames Received : 5
Number of GVRP Frames Transmitted : 2
Number of Frames Discarded : 1
GARP statistics on port GigabitEthernet2/0/2
Number of GVRP Frames Received : 3
Number of GVRP Frames Transmitted : 4
Number of Frames Discarded : 2
display garp timer
Syntax
display garp timer [ interface interface-list ] [ | { begin | exclude | include } regular-expression ]
View
Any view
Default Level
1: Monitor level
Parameters
interface interface-list: Specifies one or multiple ports. You can provide up to 10 port lists, by each of
which you can specify a single port in the form of interface-type interface-number, or a port range in
the form of interface-type interface-number1 to interface-type interface-number2, where the end port
number specified by interface-number2 must be greater than the start port number specified by
interface-number1. If no ports are specified, this command displays the GARP timer settings on all
ports.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see CLI Configuration in the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays the lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256
characters.
Description
Use the display garp timer command to display GARP timer settings on specific ports.
Related commands: garp timer hold, garp timer join, garp timer leave, and garp timer leaveall.
To Next Page
Loading...
Need help?
General
