1-1
1 Ethernet Interface Configuration Commands
Ethernet Interface Configuration Commands
broadcast-suppression
Syntax
broadcast-suppression { ratio | pps max-pps | kbps max-kbps }
undo broadcast-suppression
View
Ethernet interface view, port group view
Default Level
2: System level
Parameters
ratio: Sets the broadcast suppression threshold as a percentage of the port transmission capability, in
the range 1 to 100. The smaller the percentage, the less broadcast traffic is allowed to pass through.
pps max-pps: Sets the broadcast suppression threshold in pps to limit the number of broadcast
packets passing through the Ethernet port per second.
For 100 Mbps port, the value range is 1 to 148810.
For a Gigabit port, the value range is 1 to 1488100.
For a 10-Gigabit port, the value range is 1 to 1488100.
kbps max-bps: Sets the broadcast suppression threshold in kbps to limit the number of kilobits of
broadcast traffic passing through the Ethernet port per second.
For 100 Mbps port, the value range is 1 to 100000.
For a Gigabit port, the value range is 1 to 1000000.
For a 10-Gigabit port, the value range is 1 to 10000000.
Description
Use the broadcast-suppression command to set the broadcast suppression threshold on one or
multiple Ethernet interfaces.
Use the undo broadcast-suppression command to restore the default.
By default, Ethernet interfaces do not suppress broadcast traffic.
If you execute this command in Ethernet interface, the configuration takes effect only on the current
interface. If you execute this command in port-group view, the configuration takes effect on all the ports
in the port group.
When broadcast traffic exceeds the broadcast suppression threshold, the interface discards broadcast
packets until the broadcast traffic drops below the threshold.
To Next Page
Loading...
Need help?
General
