H3C S7500E Series

12-1
12 BPDU Tunneling Configuration Commands
BPDU Tunneling Configuration Commands
bpdu-tunnel dot1q
Syntax
In Ethernet interface view or port group view:
bpdu-tunnel dot1q { cdp | dldp | eoam | gvrp | hgmp | lacp | lldp | pagp | pvst | stp | udld | vtp }
undo bpdu-tunnel dot1q { cdp | dldp | eoam | gvrp | hgmp | lacp | lldp | pagp | pvst | stp | udld |
vtp }
In Layer 2 aggregate interface view:
bpdu-tunnel dot1q { cdp | gvrp | hgmp | pvst | stp | vtp }
undo bpdu-tunnel dot1q { cdp | gvrp | hgmp | pvst | stp | vtp }
View
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default Level
2: System level
Parameters
cdp: Specifies to enable BPDU tunneling for the Cisco Discovery Protocol (CDP)
dldp: Specifies to enable BPDU tunneling for the Device Link Detection Protocol (DLDP)
eoam: Specifies to enable BPDU tunneling for Ethernet Operation, Administration and Maintenance
(EOAM)
gvrp
: Specifies to enable BPDU tunneling for the GARP VLAN Registration Protocol (GVRP)
hgmp: Specifies to enable BPDU tunneling for the HW Group Management Protocol (HGMP)
lacp: Specifies to enable BPDU tunneling for the Link Aggregation Control Protocol (LACP)
lldp: Specifies to enable BPDU tunneling for the Link Layer Discovery Protocol (LLDP)
pagp: Specifies to enable BPDU tunneling for the Port Aggregation Protocol (PAGP)
pvst: Specifies to enable BPDU tunneling for Per VLAN Spanning Tree (PVST)
stp: Specifies to enable BPDU tunneling for the Spanning Tree Protocol (STP)
udld: Specifies to enable BPDU tunneling for Uni-directional Link Direction (UDLD)
vtp: Specifies to enable BPDU tunneling for the VLAN Trunking Protocol (VTP)
Description
Use the bpdu-tunnel dot1q command to enable BPDU tunneling for a protocol on the current port or
ports.
Use the undo bpdu-tunnel dot1q command to disable BPDU tunneling for a protocol on the port or
ports.