9-21
Examples
# Configure the aggregation group corresponding to Bridge-Aggregation 1 to work in dynamic
aggregation mode.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic
link-aggregation selected-port minimum
Syntax
link-aggregation selected-port minimum number
undo link-aggregation selected-port minimum
View
Layer 2 aggregate interface view
Default Level
2: System level
Parameters
number: Minimum number of selected ports in the current aggregation group required to bring up the
aggregate interface, in the range of 1 to 8.
Description
Use the link-aggregation selected-port minimum command to configure the minimum number of
selected ports in the current aggregation group.
Use the undo link-aggregation selected-port minimum command to restore the default.
By default, the minimum number of selected ports in an aggregation group is not specified.
Note that executing this command may cause all the member ports in the current aggregation group to
become unselected.
Examples
# Configure the minimum number of selected ports in the aggregation group corresponding to Layer 2
aggregate interface Bridge-Aggregation 1 as 3.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation selected-port minimum 3
port link-aggregation group
Syntax
port link-aggregation group number
undo port link-aggregation group
View
Ethernet interface view
Default Level
2: System level
To Next Page
Loading...
Need help?
General
