H3C S7500E Series

11-20
[Sysname] stp region-configuration
[Sysname-mst-region] instance 1 vlan 2
region-name
Syntax
region-name name
undo region-name
View
MST region view
Default Level
2: System level
Parameters
name: MST region name, a string of 1 to 32 characters.
Description
Use the region-name command to configure the MST region name.
Use the undo region-name command to restore the default MST region name.
By default, the MST region name of a device is its MAC address.
The MST region name, the VLAN-to-instance mapping table and the MSTP revision level of a device
jointly determine the MST region to which the device belongs.
After configuring this command, you need to run the active region-configuration command to
activate the configured MST region name.
Related commands: instance, revision-level, vlan-mapping modulo, display stp
region-configuration, check region-configuration, and active region-configuration.
Examples
# Set the MST region name of the device to hello.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] region-name hello
reset stp
Syntax
reset stp [ interface interface-list ]
View
User view
Default Level
1: Monitor level