H3C S7500E Series

8-3
<Sysname> system-view
[Sysname] mac-address information interval 200
mac-address information mode
Syntax
mac-address information mode { syslog | trap }
undo mac-address information mode { syslog | trap }
View
System view
Default Level
2: System level
Parameters
syslog: Specifies that the device sends Syslog messages to inform the remote network management
device of MAC address changes.
trap: Specifies that the device sends trap messages to inform the remote network management device
of MAC address changes.
Description
Use the mac-address information mode command to set the MAC Information mode, that is,
whether to use Syslog messages or trap messages to inform the remote network management device
of MAC address changes.
Use the undo mac-address information mode command to restore the default.
By default, trap messages are sent to inform the remote network management device of MAC address
changes.
Examples
# Configure the device to send trap messages to inform the remote network management device of
MAC address changes.
<Sysname> system-view
[Sysname] mac-address information mode trap
mac-address information queue-length
Syntax
mac-address information queue-length value
undo mac-address information queue-length
View
System view
Default Level
2: System level
Parameters
value: MAC Information queue length. The value range is 0 to 1000.