10-2
Table 10-1 display port-isolate group command output description
Field Description
Uplink port support
The S7500E series switches do not support the uplink port
configuration for port isolation. On some devices, a port
isolation group may contain one uplink port, which can
communicate with all isolated ports at Layer 2 in the
isolation group.
Group ID Isolation group number
Group members Isolated ports in the isolation group
port-isolate enable
Syntax
port-isolate enable
undo port-isolate enable
View
Ethernet interface view, Layer-2 aggregate interface view, port group view
Default Level
2: System level
Parameters
None
Description
Use the port-isolate enable command to assign a port to the isolation group.
Use the undo port-isolate enable command to remove a port from the isolation group.
To assign Ethernet ports to the isolation group one by one, perform the command in Ethernet
interface view.
To bulk assign Ethernet ports to the isolation group, perform the command in port group view.
To assign a Layer 2 aggregate interface to the isolation group, perform the command in Layer-2
aggregate interface view. The configuration applies to the Layer-2 aggregate interface and all its
member ports. If the switch fails to apply the port-isolate enable command to a Layer 2
aggregate interface, it does not assign any member port of the aggregate interface to the isolation
group. If the failure occurs on a member port, the switch can still assign other member ports to the
isolation group. For detailed information about Layer 2 aggregate interfaces, see Ethernet Link
Aggregation Configuration in the Layer 2 - LAN Switching Configuration Guide.
To Next Page
Loading...
Need help?
General
