3-25
Default Level
2: System level
Parameters
vlan-id: VLAN ID, in the range of 1 to 4,094
Description
Use the port trunk pvid vlan command to set the default VLAN ID of the ONU port configured as a
trunk port.
Use the undo port trunk pvid command to restore the default.
By default, the default VLAN on a Trunk port is VLAN 1.
For a Trunk port, after you execute the undo vlan command to remove the default VLAN of the Trunk
port, the default VLAN of the Trunk port does not change. That is to say, the Trunk port can use the
non-existing VLAN as the default VLAN.
Related commands: port link-type.
Examples
# Configure the default VLAN ID for the Trunk port ONU 3/0/1:1 as 100.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] port link-type trunk
[Sysname-Onu3/0/1:1] port trunk pvid vlan 100
reboot onu
Syntax
reboot onu
View
ONU port view
Default Level
2: System level
Parameters
None
Description
Use the reboot onu command to restart the ONU.
Before using this command, make sure the ONU is online.
Examples
# Restart ONU 3/0/1:1.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] reboot onu
reset counters uni
Syntax
reset counters uni [ uni-number ]
To Next Page
Loading...
Need help?
General
