H3C S7500E Series Command Reference

13-34
Table 13-7 display ip-subnet-vlan vlan command output description
Field Description
Subnet Index IP subnet index
IP Address IP address of the subnet (can be an IP address or a network address)
Subnet Mask Mask of the IP subnet
ip-subnet-vlan
Syntax
ip-subnet-vlan [ ip-subnet-index ] ip ip-address [ mask ]
undo ip-subnet-vlan { ip-subnet-index [ to ip-subnet-end ] | all }
View
VLAN view
Default Level
2: System level
Parameters
ip-subnet-index: Beginning IP subnet Index, in the range of 0 to 11. This value can be configured by
users, or automatically numbered by system based on the order in which the IP subnets or IP
addresses are associated with the VLAN.
ip ip-address [mask]: Specifies the source IP address or network address based on which the
subnet-based VLANs are classified, in dotted decimal notation. The mask argument is the subnet
mask of the source IP address or network address, in dotted decimal notation with a default value of
255.255.255.0.
to: Specifies an IP subnet index range.
ip-subnet-end: End IP subnet index, in the range of 0 to 11. This argument must be greater than or
equal to the beginning IP subnet index.
all: Removes all the associations between VLANs and IP subnets or IP addresses.
Description
Use the ip-subnet-vlan command to associate the current VLAN with a specified IP subnet or IP
address.
Use the undo ip-subnet-vlan command to remove the association.
Note that the IP subnet or IP address cannot be a multicast network segment or a multicast address.
Related commands: display ip-subnet-vlan vlan.
Examples
# Configure VLAN 3 as an IP subnet-based VLAN and associate it with the 192.168.1.0/24 network
segment.
<Sysname> system-view
[Sysname] vlan 3

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English