9-17
Parameters
system-priority: LACP priority of the local system, in the range of 0 to 65535. The smaller this value,
the higher the system LACP priority.
Description
Use the lacp system-priority command to set the LACP priority of the local system.
Use the undo lacp system-priority command to restore the default.
By default, the system LACP priority is 32768.
Examples
# Set the system LACP priority to 64.
<Sysname> system-view
[Sysname] lacp system-priority 64
link-aggregation lacp traffic-redirect-notification enable
Syntax
link-aggregation lacp traffic-redirect-notification enable
undo link-aggregation lacp traffic-redirect-notification enable
View
System view
Default Level
2: System level
Parameters
None
Description
Use the link-aggregation lacp traffic-redirect-notification enable command to enable
link-aggregation traffic redirection.
Use the undo link-aggregation lacp traffic-redirect-notification enable command to disable
link-aggregation traffic redirection.
By default, link-aggregation traffic redirection is disabled.
Note that:
Link-aggregation traffic redirection applies to dynamic link aggregation groups only.
To prevent traffic interruption, you need to enable link-aggregation traffic redirection on devices at
both ends of the aggregate link.
You are recommended not to enable both MSTP and link-aggregation traffic redirection. If they
are both enabled, light packet loss may occur when a card/device reboots.
Examples
# Enable link-aggregation traffic redirection.
<Sysname> system-view
[Sysname] link-aggregation lacp traffic-redirect-notification enable
To Next Page
Loading...
Need help?
General
