H3C S7500E Series

15-1
15 Isolate-User-VLAN Configuration Commands
Isolate-User-VLAN Configuration Commands
display isolate-user-vlan
Syntax
display isolate-user-vlan [ isolate-user-vlan-id ] [ | { begin | exclude | include } regular-expression ]
View
Any view
Default Level
1: Monitor level
Parameters
isolate-user-vlan-id: Isolate-user-VLAN ID, in the range of 1 to 4094.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see CLI Configuration in the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays the lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256
characters.
Description
Use the display isolate-user-vlan command to display the mapping between an isolate-user-VLAN
and secondary VLAN(s).
Related commands: isolate-user-vlan and isolate-user-vlan enable.
Examples
# Display the mapping between an isolate-user-VLAN and secondary VLANs.
<Sysname> display isolate-user-vlan
Isolate-user-VLAN VLAN ID : 2
Secondary VLAN ID : 3 4
VLAN ID: 2
VLAN Type: static
Isolate-user-VLAN type : isolate-user-VLAN
Route Interface: configured
IP Address: 1.1.1.1
Subnet Mask: 255.255.255.0
Description: VLAN 0002
Name: VLAN 0002
Tagged Ports: none