3-36
View
ONU port view
Default Level
2: System level
Parameters
uni-number: UNI number, in the range 1 to the number of UNI ports of the current ONU. The number of
UNIs can be up to 80.
Description
Use the uni shutdown command to disable the UNIs.
Use the undo uni shutdown command to enable the UNIs.
By default, all the UNIs are disabled.
Examples
# Disable UNI 1.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] uni 1 shutdown
uni speed
Syntax
uni uni-number speed { 10 | 100 | auto }
undo uni uni-number speed
View
ONU port view
Default Level
2: System level
Parameters
uni-number: UNI number, in the range 1 to the number of UNI ports of the current ONU. The number of
UNIs can be up to 80.
10: Specifies the port speed to 10 Mbps.
100: Specifies the port speed to 100 Mbps.
auto: Specifies the port speed to be auto-negotiated.
Description
Use the uni uni-number speed command to set the operating speed for a UNI.
Use the undo uni uni-number speed command to restore the default operating speed for a UNI.
By default, the operating speed of a UNI port is 100Mbps.
This command takes effect on H3C ONUs only.
To Next Page
Loading...
Need help?
General
