H3C S7500E Series

15-4
[Sysname-vlan2] port gigabitethernet 2/0/2
[Sysname-vlan2] vlan 3
[Sysname-vlan3] port gigabitethernet 2/0/3
[Sysname-vlan3] vlan 4
[Sysname-vlan4] port gigabitethernet 2/0/4
[Sysname-vlan4] quit
[Sysname] isolate-user-vlan 2 secondary 3 to 4
isolate-user-vlan enable
Syntax
isolate-user-vlan enable
undo isolate-user-vlan enable
View
VLAN view
Default Level
2: System level
Parameters
None
Description
Use the isolate-user-vlan enable command to configure the current VLAN as an isolate-user-VLAN.
Use the undo isolate-user-vlan enable command to remove the isolate-user-VLAN configuration for
the current VLAN.
By default, no VLAN is an isolate-user-VLAN.
An isolate-user-VLAN may include multiple ports, including the one connected to the upstream device.
Related commands: display isolate-user-vlan.
Examples
# Configure VLAN 5 as an isolate-user-VLAN.
<Sysname> system-view
[Sysname] vlan 5
[Sysname-vlan5] isolate-user-vlan enable
isolated-vlan enable
Syntax
isolated-vlan enable
undo isolated-vlan enable
View
VLAN view
Default Level
2: System level