EasyManuals Logo

H3C S7500E Series Command Reference

H3C S7500E Series
368 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #350 background imageLoading...
Page #350 background image
20-20
<Sysname> system-view
[Sysname] lldp compliance cdp
lldp enable
Syntax
lldp enable
undo lldp enable
View
System view, Layer 2 Ethernet interface view, port group view
Default level
2: System level
Parameters
None
Description
Use the lldp enable command to enable LLDP.
Use the undo lldp enable command to disable LLDP.
By default, LLDP is disabled globally and enabled on a port.
LLDP takes effect on a port only when LLDP is enabled both globally and on the port.
Examples
# Disable LLDP on GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] undo lldp enable
lldp encapsulation snap
Syntax
lldp encapsulation snap
undo lldp encapsulation
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
Parameters
None
Description
Use the lldp encapsulation snap command to configure the encapsulation format for LLDPDUs as
SNAP on a port or a group of ports.
Use the undo lldp encapsulation command to restore the default encapsulation format for LLDPDUs.
By default, Ethernet II encapsulation applies.

Table of Contents

Other manuals for H3C S7500E Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S7500E Series and is the answer not in the manual?

H3C S7500E Series Specifications

General IconGeneral
BrandH3C
ModelS7500E Series
CategorySwitch
LanguageEnglish

Related product manuals