H3C S7500E Series

9-18
link-aggregation load-sharing mode
Syntax
System view:
link-aggregation load-sharing mode { destination-ip | destination-mac | destination-port |
ingress-port | source-ip | source-mac | source-port } *
undo link-aggregation load-sharing mode
Layer 2 aggregate interface view:
link-aggregation load-sharing mode { { destination-ip | destination-mac | mpls-label1 |
mpls-label2 | source-ip | source-mac } * | flexible }
undo link-aggregation load-sharing mode
View
System view, Layer 2 aggregate interface view
Default Level
2: System level
Parameters
destination-ip: Specifies to perform load sharing in link aggregation groups based on destination IP
address.
destination-mac: Specifies to perform load sharing in link aggregation groups based on destination
MAC address.
destination-port: Specifies to perform load sharing in link aggregation groups based on destination
port.
ingress-port: Specifies to perform load sharing in link aggregation groups based on ingress port.
mpls-label1: Specifies to perform load sharing for MPLS traffic based on layer 1 label.
mpls-label2: Specifies to perform load sharing for MPLS traffic based on layer 2 label.
source-ip: Specifies to perform load sharing in link aggregation groups based on source IP address.
Support for this keyword depends on your device model and current view.
source-mac: Specifies to perform load sharing in link aggregation groups based on source MAC
address.
source-port: Specifies to perform load sharing in link aggregation groups based on source port.
flexible: Specifies to perform load sharing in load-sharing link aggregation groups flexibly based on
packet types (Layer 2, IPv4, IPv6, or MPLS for example).
Description
Use the link-aggregation load-sharing mode command to configure the global or group-specific
link-aggregation load sharing criterion or criteria.
Use the undo link-aggregation load-sharing mode command to restore the default.
By default, the system automatically chooses the global link-aggregation load sharing criterion or
criteria based on packet types. For example, for Layer 2 traffic, the default are the source/destination
MAC addresses and the ingress port of packets; for Layer 3 traffic, the default are the
source/destination IP addresses of packets.. The global link-aggregation load sharing criterion or
criteria are the default for all link aggregation groups.