1-10
Field Description
--: not supported. The statistical item is not supported.
display interface
Syntax
display interface [ interface-type [ interface-number ] ] [ | { begin | exclude | include }
regular-expression ]
View
Any view
Default Level
1: Monitor level
Parameters
interface-type: Specifies an interface type.
interface-number: Specifies an interface number.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see CLI Configuration in the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays the lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256
characters.
Description
Use the display interface command to display detailed information about interfaces, including their
operating status.
If neither interface type nor interface number is specified, the command displays detailed
information about all interfaces.
If only interface type is specified, the command displays detailed information about all interfaces of
the particular type.
If both interface type and interface number are specified, the command displays detailed
information about only the specified interface.
Related commands: interface.
Examples
# Display detailed information about interface GigabitEthernet 2/0/1.
<Sysname> display interface gigabitethernet 2/0/1
GigabitEthernet2/0/1 current state: DOWN
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 0023-8927-b001
Description: GigabitEthernet2/0/1 Interface
Loopback is not set
Media type is twisted pair
Port hardware type is 1000_BASE_T
Unknown-speed mode, unknown-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
To Next Page
Loading...
Need help?
General
