1-9
outbound: Displays outbound traffic rate statistics.
interface-type: Specifies an interface type.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see CLI Configuration in the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays the lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256
characters.
Description
Use the display counters rate command to display traffic rate statistics over the last sampling
interval.
The statistics cover only interfaces in up state. If an interface type is specified, the command displays
traffic rate statistics for all up interfaces of the specified type. If no interface type is specified, the
command displays traffic rate statistics for all up interfaces that have traffic counters.
As for the sampling interval, you can use the flow-interval command to set the sampling interval. The
system default is five minutes.
Related commands: flow-interval.
Examples
# Display inbound traffic rate statistics for all GigabitEthernet interfaces.
<Sysname> display counters rate inbound interface gigabitethernet
Interface Total(pkts/sec) Broadcast(pkts/sec) Multicast(pkts/sec)
GE2/0/1 0 -- --
Overflow: more than 14 decimal digits.
--: not supported.
Table 1-4 display counters rate command output description
Field Description
Interface Abbreviated interface name
Total (pkts/sec)
Average rate (in packets per second) of receiving/sending packets during the
sampling interval. You can specify the direction of the packets using the
inbound
and
outbound
keyword.
Broadcast (pkts/sec)
Average rate (packets per second) of receiving/sending broadcast packets
during the sampling interval. You can specify the direction of the packets
using the
inbound
and
outbound
keyword.
Multicast (pkts/sec)
Average rate (packets per second) of receiving/sending multicast packets
during the sampling interval. You can specify the direction of the packets
using the
inbound
and
outbound
keyword.
Overflow: more than 14
decimal digits.
The command displays
Overflow
, if:
The data length of an error statistic is greater than 7 decimal digits.
The data length of a statistic of any other type is greater than 14 decimal
digits.
To Next Page
Loading...
Need help?
General
