1-32
auto: Sets the MDI mode to auto. In this mode, the port negotiates pin roles with its peer.
normal: Sets the MDI mode to normal. In normal mode, pins 1 and 2 of the port are transmit pins, and
pins 3 and 6 are receive pins.
Description
Use the mdi command to configure the MDI mode of a copper Ethernet interface.
Use the undo mdi command to restore the default.
By default, Ethernet interfaces operate in auto MDI mode.
This command is not applicable to optical ports.
Examples
# Set interface GigabitEthernet 2/0/1 to operate in across MDI mode.
<Sysname> system-view
[Sysname] interface gigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] mdi across
multicast-suppression
Syntax
multicast-suppression { ratio | pps max-pps | kbps max-kbps }
undo multicast-suppression
View
Ethernet interface view
Default Level
2: System level
Parameters
ratio: Sets the multicast suppression threshold as a percentage of the port transmission capability, in
the range 1 to 100. The smaller the percentage, the less multicast traffic is allowed to pass through.
pps max-pps: Sets the multicast suppression threshold in pps to limit the number of multicast packets
passing through the Ethernet port per second.
For 100 Mbps port, the value range is 1 to 148810.
For a Gigabit port, the value range is 1 to 1488100.
For a 10-Gigabit port, the value range is 1 to 1488100.
kbps max-bps: Sets the multicast suppression threshold in kbps to limit the number of kilobits of
broadcast traffic passing through the Ethernet port per second.
For 100 Mbps port, the value range is 1 to 100000
For a Gigabit port, the value range is 1 to 1000000.
For a 10-Gigabit port, the value range is 1 to 10000000.
To Next Page
Loading...
Need help?
General
