3-30
Use the undo uni igmp-snooping fast-leave command to disable this function.
By default, fast leave is disabled on a UNI.
Examples
# Enable fast leave on UNI 1.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] uni 1 igmp-snooping fast-leave
uni mdi
Syntax
uni uni-number mdi { across | auto | normal }
undo uni uni-number mdi
View
ONU port view
Default Level
2: System level
Parameters
uni-number: UNI number, in the range 1 to the number of UNI ports of the current ONU. The number of
UNIs can be up to 80.
across: Specifies the cable type to be crossover.
auto: Specifies to auto-sense the cable type.
normal: Specifies the cable type to be straight-through.
Description
Use the uni mdi command to set the MDI mode for UNIs.
Use the undo uni uni-number mdi command to restore the MDI mode for UNIs to the default value.
By default, the MDI mode for UNIs is auto, that is, the UNIs of the ONU can recognize the cable type
automatically.
This command takes effect on H3C ONUs only.
Examples
# Set the MDI mode of UNI 1 to auto.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] uni 1 mdi auto
uni multicast vlan
Syntax
uni uni-number multicast vlan { vlan-id } & <1-50>
To Next Page
Loading...
Need help?
General
