17-9
Examples
# Set the GARP Join timer to 25 centiseconds, assuming that both the Hold timer and the Leave timer
are using the default.
<Sysname> system-view
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] garp timer join 25
garp timer leave
Syntax
garp timer leave timer-value
undo garp timer leave
View
Ethernet interface view, Layer-2 aggregate interface view, port group view
Default Level
2: System level
Parameters
timer-value: Leave timer setting (in centiseconds), which must be a multiple of 5 between two times the
Join timer (exclusive) and the LeaveAll timer setting (exclusive).
Description
Use the garp timer leave command to set the GARP Leave timer for an Ethernet port, Layer-2
aggregate interface, or all ports in a port group.
Use the undo garp timer leave command to restore the default of the GARP Leave timer. This may
fail if the default is beyond the valid value range for the Leave timer.
By default, the Leave timer is set to 60 centiseconds.
Related commands: display garp timer, garp timer join, and garp timer leaveall.
Examples
# Set the GARP Leave timer to 100 centiseconds, assuming that both the Join timer and the LeaveAll
timer are using the default.
<Sysname> system-view
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] garp timer leave 100
garp timer leaveall
Syntax
garp timer leaveall timer-value
undo garp timer leaveall
View
System view
Default Level
2: System level
To Next Page
Loading...
Need help?
General
