H3C S7500E Series

3-21
undo onu port-isolate enable
View
ONU port view
Default Level
2: System level
Parameters
None
Description
Use the onu port-isolate enable command to isolate all UNI ports of the ONU.
Use the undo onu port-isolate enable command to disable UNI port isolation.
By default, UNI port isolation is disabled.
Examples
# Isolate all UNI ports attached to the ONU corresponding to ONU 3/0/1:1.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] onu port-isolate enable
onu-protocol enable
Syntax
onu-protocol { stp | dhcp-snooping | dhcp-snooping information | pppoe } enable
undo onu-protocol { stp | dhcp-snooping | dhcp-snooping information | pppoe } enable
View
ONU port view
Default Level
2: System level
Parameters
stp: Enables RSTP for the ONU.
dhcp-snooping: Enables DHCP-Snooping for the ONU.
dhcp-snooping information: Enables DHCP-Snooping Option82 for the ONU.
pppoe: Enables PPPoE+ for the ONU.