9-24
Description
Use the shutdown command to shut down the current aggregate interface.
Use the undo shutdown command to bring up the current aggregate interface.
By default, aggregate interfaces are up.
Examples
# Shut down Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] shutdown
synchronization mac-address enable
Syntax
synchronization mac-address enable
undo synchronization mac-address enable
View
System view
Default Level
2: System level
Parameters
None
Description
Use the synchronization mac-address enable command to enable MAC address table
synchronization between line cards.
Use the undo synchronization mac-address enable command to restore the default.
By default, MAC address table synchronization is disabled between some types of cards. See Link
Aggregation Configuration for more information.
Examples
# Enable MAC address table synchronization between line cards.
<Sysname> system-view
[Sysname] synchronization mac-address enable
To Next Page
Loading...
Need help?
General
