17-11
<Sysname> system-view
[Sysname] gvrp
GVRP is enabled globally.
gvrp registration
Syntax
gvrp registration { fixed | forbidden | normal }
undo gvrp registration
View
Ethernet interface view, Layer-2 aggregate interface view, port group view
Default Level
2: System level
Parameters
fixed: Sets the GVRP registration mode to fixed.
forbidden: Sets the GVRP registration mode to forbidden.
normal: Sets the GVRP registration mode to normal.
Description
Use the gvrp registration command to configure the GVRP registration mode on a port (in Ethernet or
Layer-2 aggregate interface view) or all ports in a port group (in port group view).
Use the undo gvrp registration command to restore the default on a port, or on all ports in a port
group depending on the view the command is executed.
The default GVRP registration mode is normal.
Note that, this command is only available on trunk ports.
Related commands: display garp statistics.
Examples
# Set the GVRP registration mode to fixed on port GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] port link-type trunk
[Sysname-GigabitEthernet2/0/1] gvrp registration fixed
reset garp statistics
Syntax
reset garp statistics [ interface interface-list ]
View
User view
Default Level
2: System level
To Next Page
Loading...
Need help?
General
