17-5
Field Description
Registrar state machine
The Registrar state machine records the registration of attributes declared by other
participants. Its state can be INN, LV, L3, L2, L1, MT, INR, LVR, L3R, L2R, L1R,
MTR, INF, LVF, L3F, L2F, L1F, and MTF. Each state consists of two or three
letters/numbers, the meanings of which are as follows:
The first two letters/numbers indicate the state: IN stands for In; LV, L3, L2, and
L1 all stand for Leaving, and L3, L2, L1 are three sub-states of LV; MT stands
for Empty
The third letter indicates the registration mode: N (or the third letter being
absent) for Normal registration, R for Registration fixed, and F for Registration
forbidden.
For example, MTR stands for “Empty, Registration fixed", indicating the fixed
registration mode in Empty state.
display gvrp statistics
Syntax
display gvrp statistics [ interface interface-list ] [ | { begin | exclude | include } regular-expression ]
View
Any view
Default Level
1: Monitor level
Parameters
interface interface-list: Defines one or multiple Ethernet ports. You can provide up to 10 Ethernet port
lists, by each of which you can specify an individual port in the form of interface-type interface-number,
or a port range in the form of interface-type interface-number1 to interface-type interface-number2,
where the end-port number specified by interface-number2 must be greater than the start-port number
specified by interface-number1. If no ports are specified, this command displays the GVRP statistics
for all trunk ports.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see CLI Configuration in the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays the lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256
characters.
Description
Use the display gvrp statistics command to display the GVRP statistics of the specified or all trunk
ports.
To Next Page
Loading...
Need help?
General
