17-4
View
Any view
Default Level
0: Visit level
Parameters
interface interface-type interface-number: Specifies an interface by its type and number.
vlan vlan-id: Specifies a VLAN ID, in the range of 1 to 4094.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see CLI Configuration in the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays the lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256
characters.
Description
Use the display gvrp state command to display GVRP state machines in a specified VLAN on a port.
Examples
# Display GVRP state machines in VLAN 2 on port GigabitEthernet 2/0/1.
<Sysname> display gvrp state interface GigabitEthernet 2/0/1 vlan 2
GVRP state of VLAN 2 on port GigabitEthernet2/0/1
Applicant state machine : VP
Registrar state machine : MTR
Table 17-1 display gvrp state command output description
Field Description
GVRP state of VLAN 2
on port
GigabitEthernet2/0/1
Information about the GVRP state machines in VLAN 2 on port GigabitEthernet
2/0/1
Applicant state machine
The Applicant state machine handles attribute declarations. Its state can be VA,
AA, QA, LA, VP, AP, QP, VO, AO, QO, LO, VON, AON, and QON. Each state
consists of two or three letters, the meanings of which are as follows:
The first letter indicates the state: V for Very anxious, A for Anxious, Q for
Quiet, and L for Leaving.
The second letter indicates the membership state: A for Active member, P for
Passive member, and O for Observer.
The second letter N (if any) stands for Non-participant.
For example, VP indicates “Very anxious, Passive member".
To Next Page
Loading...
Need help?
General
