H3C S7500E Series

9-7
Table 9-3 display link-aggregation load-sharing mode command output description
Field Description
Link-Aggregation Load-Sharing
Mode
The global link-aggregation load sharing criteria.
 By default, the link-aggregation load sharing criteria for Layer 2 and
Layer 3 traffic are displayed
 If you have configured the global link-aggregation load sharing
criteria, the configured ones are displayed.
Bridge-Aggregation10
Load-Sharing Mode
Link-aggregation load sharing criteria of the aggregation group
corresponding to aggregate interface Bridge-Aggregation 10
 By default, the global link-aggregation load sharing criteria are
displayed.
 If you have configured link-aggregation load sharing criteria
especially for this aggregation group, the configured ones are
displayed.
Layer 2 traffic: ingress-port,
destination-mac address,
source-mac
address
The default load sharing criteria for Layer 2 traffic. In this sample output,
it is based on source MAC address, ingress port , and destination MAC
address.
Layer 3 traffic: destination-ip
address, source-ip address
The default load sharing criteria for Layer 3 traffic. In this sample output,
it is based on source IP address and destination IP address.
destination-mac address,
source-mac address
The user-configured link-aggregation load sharing criteria. In this sample
output, the criteria are the source and destination MAC addresses of
packets.
display link-aggregation member-port
Syntax
display link-aggregation member-port [ interface-list ] [ | { begin | exclude | include }
regular-expression ]
View
Any view
Default Level
1: Monitor level
Parameters
interface-list: Link aggregation member port list, in the form of interface-type interface-number [ to
interface-type interface-number ], where interface-type interface-number indicates port type and port
number.