H3C S7500E Series

9-6
Description
Use the display link-aggregation load-sharing mode command to display global or group-specific
link-aggregation load sharing criterion or criteria.
Note that:
 To display the global link-aggregation load sharing criterion or criteria, run the command without
the interface keyword.
 To display all the group-specific load sharing criteria, run the command with the interface
keyword but do not specify a particular interface.
 To display the load sharing criterion or criteria of a particular aggregation group, perform the
command with the aggregate interface specified.
 The bridge-aggregation keyword becomes available only after you create Layer 2 aggregate
interfaces on the device.
Examples
# Display the default global link-aggregation load sharing criteria.
<Sysname> display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
Layer 2 traffic: ingress-port, destination-mac address,
source-mac address
Layer 3 traffic: destination-ip address, source-ip address
# Display the configured global link-aggregation load sharing criteria.
<Sysname> display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
destination-mac address, source-mac address
# Display the default link-aggregation load sharing criteria of the aggregation group corresponding to
Layer 2 aggregate interface Bridge-Aggregation 10.
<Sysname> display link-aggregation load-sharing mode interface bridge-aggregation 10
Bridge-Aggregation10 Load-Sharing Mode:
Layer 2 traffic: ingress-port, destination-mac address,
source-mac address
Layer 3 traffic: destination-ip address, source-ip address
# Display the configured link-aggregation load sharing criterion or criteria of the aggregation group
corresponding to Layer 2 aggregate interface Bridge-Aggregation 10.
<Sysname> display link-aggregation load-sharing mode interface bridge-aggregation 10
Bridge-Aggregation10 Load-Sharing Mode:
destination-mac address, source-mac address