H3C S7500E Series

11-31
Examples
# Enable No Agreement Check on GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] stp no-agreement-check
stp pathcost-standard
Syntax
stp pathcost-standard { dot1d-1998 | dot1t | legacy }
undo stp pathcost-standard
View
System view
Default Level
2: System level
Parameters
dot1d-1998: The device calculates the default path cost for ports based on IEEE 802.1d-1998.
dot1t: The device calculates the default path cost for ports based on IEEE 802.1t.
legacy: The device calculates the default path cost for ports based on a private standard.
Description
Use the stp pathcost-standard command to specify a standard for the device to use when calculating
the default path costs for ports of the device.
Use the undo stp pathcost-standard command to restore the system default.
By default, the device calculates the default path cost for ports based on a private standard.
If you change the standard that the device uses in calculating the default path costs, you restore the
path costs to the default.
Related commands: stp cost and display stp.
Examples
# Configure the device to calculate the default path cost for ports based on IEEE 802.1d-1998.
<Sysname> system-view
[Sysname] stp pathcost-standard dot1d-1998
stp point-to-point
Syntax
stp point-to-point { auto | force-false | force-true }
undo stp point-to-point
View
Layer 2 Ethernet interface view, port group view, Layer 2 aggregate interface view
Default Level
2: System level