3-38
Pair polarity: -
Insertion loss: - db
Return loss: - db
Near-end crosstalk: - db
Table 3-8 uni virtual-cable-test command output description
Field Description
Cable status
Cable state, which can be normal, abnormal, abnormal(open),
abnormal(short), or failure.
Pair Impedance mismatch
Pair impedance mismatch. The hyphen “-” indicates that the test item is not
supported.
Pair skew
Pair skew. The hyphen “-” indicates that the test item is not supported.
Pair swap
Pair swap. The hyphen “-” indicates that the test item is not supported.
Pair polarity
Pair polarity. The hyphen “-” indicates that the test item is not supported.
Insertion loss Insertion loss. The hyphen “-” indicates that the test item is not supported.
Return loss Return loss. The hyphen “-” indicates that the test item is not supported.
Near-end crosstalk
Near-end crosstalk. The hyphen “-” indicates that the test item is not
supported.
uni vlan-mode tag pvid
Syntax
uni uni-number vlan-mode tag pvid pvid [ priority priority-value ]
undo uni uni-number vlan-mode
View
ONU port view
Default Level
2: System level
Parameters
uni-number: UNI number, in the range 1 to the number of current ONU UNIs. The maximum number of
UNI ports supported is 80.
Value: 802.1p precedence value of a packet, in the range of 0 to 7.
pvid: Default VLAN ID, in the range 1 to 4094.
Description
Use the uni vlan-mode tag pvid command to configure the VLAN operation mode of the specified
UNI as the VLAN tag mode and set the related parameters.
Use the undo uni vlan-mode command to restore the default VLAN operation mode of the UNI.
By default, the VLAN operation mode of a UNI is VLAN transparent transmission mode.
Related command: uni vlan-mode translation pvid, uni vlan-mode transparent.
To Next Page
Loading...
