H3C S7500E Series Command Reference

1-43
 For a Gigabit port, the value range is 1 to 1000000.
 For a 10-Gigabit port, the value range is 1 to 10000000.
Description
Use the unicast-suppression command to set the unknown unicast suppression threshold on an
Ethernet interface view or a group of Ethernet interfaces in port group view.
Use the undo unicast-suppression command to restore the default.
By default, Ethernet interfaces do not suppress unknown unicast traffic.
If you execute this command in Ethernet interface view, the configurations take effect only on the
current interface. If you execute this command in port-group view, the configurations take effect on all
ports in the port group
When unknown unicast traffic exceeds the threshold you configure, the system discards unknown
unicast packets until the unknown unicast traffic drops below the threshold.
 If you set different unknown unicast suppression thresholds in Ethernet interface view or
port-group view multiple times, the one configured last takes effect.
 For a particular type of traffic, configure either storm suppression or storm control, but not both. If
both of them are configured, you may fail to achieve the expected storm control effect.
Examples
# Set the unknown unicast threshold to 20% on Ethernet interface GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] interface gigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] unicast-suppression 20
# Set the unknown unicast threshold to 20% on all ports of port group group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member gigabitethernet 2/0/1
[Sysname-port-group-manual-group1] group-member gigabitethernet 2/0/2
[Sysname-port-group-manual-group1] unicast-suppression 20
virtual-cable-test
Syntax
virtual-cable-test
View
Ethernet interface view
Default Level
2: System level
Parameters
None

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English