2-25
Examples
# In OLT port view, add OLT 3/0/1 to fiber backup group 1.
<Sysname> system-view
[Sysname] ftth
[Sysname-ftth] fiber-backup group 1
Create group ID successfully.
[Sysname-fiber-group1] quit
[Sysname] interface olt 3/0/1
[Sysname-Olt3/0/1] port fiber-backup group 1
port hybrid pvid vlan
Syntax
port hybrid pvid vlan vlan-id
undo port hybrid pvid
View
OLT port view
Default Level
2: System level
Parameters
vlan-id: VLAN ID, in the range of 1 to 4094.
Description
Use the port hybrid pvid vlan command to configure the default VLAN ID of the hybrid port.
Use the undo port hybrid pvid command to restore the default.
By default, the default VLAN of a hybrid port is VLAN 1.
To add default VLAN tags to the untagged inbound packets on an OLT port, make sure the default
VLAN ID is configured for the OLT port and QinQ is enabled on the port (by using the qinq enable
command).
Examples
# Configure VLAN 100 as the default VLAN of the hybrid port OLT 2/0/1.
<Sysname> system-view
[Sysname] vlan 100
[Sysname-vlan100] quit
[Sysname] interface olt 2/0/1
[Sysname-Olt2/0/1] port hybrid pvid vlan 100
port hybrid vlan
Syntax
port hybrid vlan vlan-id-list { tagged | untagged }
undo port hybrid vlan vlan-id-list
To Next Page
Loading...
Need help?
General
