11-30
View
System view
Default Level
2: System level
Parameters
stp: Configures the MSTP-enabled device to work in STP-compatible mode.
rstp: Configures an MSTP-enabled device to work in RSTP mode.
mstp: Configures an MSTP-enabled device to work in MSTP mode.
Description
Use the stp mode command to configure the MSTP work mode of the device.
Use the undo stp mode command to restore the MSTP work mode to the default setting.
By default, an MSTP-enabled device works in MSTP mode.
Related commands: stp mcheck and stp enable.
Examples
# Configure the MSTP-enabled device to work in STP-compatible mode.
<Sysname> system-view
[Sysname] stp mode stp
stp no-agreement-check
Syntax
stp no-agreement-check
undo stp no-agreement-check
View
Layer 2 Ethernet interface view, port group view, Layer 2 aggregate interface view
Default Level
2: System level
Parameters
None
Description
Use the stp no-agreement-check command to enable No Agreement Check on the port(s).
Use the undo stp no-agreement-check command to disable No Agreement Check on the port(s).
By default, No Agreement Check is disabled.
Configured in Layer 2 Ethernet interface view, the setting takes effect on the current interface only.
Configured in port group view, the setting takes effect on all member ports in the port group.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate interface.
Configured on a member port in an aggregation group, the setting can take effect only after the port
leaves the aggregation group.
This feature takes effect only after you enable it on the root port.
To Next Page
Loading...
Need help?
General
