3-6
display onu-protocol
Syntax
display onu-protocol [ stp | igmp-snooping | dhcp-snooping information ]
View
ONU port view
Default Level
2: System level
Parameters
stp: Displays the information about RSTP supported by the ONU.
igmp-snooping: Displays the information about IGMP snooping supported by the ONU.
dhcp-snooping information: Displays the information about DHCP-Snooping Option82 supported by
the ONU.
Description
Use the display onu-protocol command to display the information about the protocols supported by
an ONU that is in up state.
If no parameter is specified, the information about all the protocols that the ONU supports is displayed.
This command takes effect on H3C ONUs only.
STP runs normally only when all attached ONUs are H3C ONUs.
The output of this command may vary with ONU models.
Examples
# Display the information about IGMP snooping supported by the ONU.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] display onu-protocol igmp-snooping
Protocol name: IGMP snooping
Protocol status: enabled
Total 4 MAC Group(s).
group:0100-5e01-0140
port :9
group:0100-5e01-013f
port :9
group:0100-5e01-013e
port :9
group:0100-5e01-013d
port :9
Table 3-3 display onu-protocol igmp-snooping command output description
Field Description
Protocol name: IGMP snooping Protocol name
To Next Page
Loading...
Need help?
General
