3-5
[Sysname-Onu3/0/1:1] display epon-multicast information
Multicast-control information: None.
# Display multicast control information when the multicast mode of the ONU is multicast control mode
and multicast control information is generated.
[Sysname-Onu3/0/1:1] display epon-multicast information
Multicast-control information:
-------------------------------
UNI number 1:
Multicast vlan 10
Current channel list:
multicast ip:225.0.0.2
status:permit
Multicast vlan 10
Current channel list:
multicast ip:225.0.0.3
status:preview
preview times:16
preview remain time:144s
Table 3-2 display epon-multicast information command output description
Field Description
ONU is not in multicast-control mode.
The multicast control mode of the ONU is IGMP snooping. No
multicast control information is available now.
Multicast-control information: None.
The multicast control mode of the ONU is multicast control mode
but no multicast control information is generated. There are two
reasons for this:
No multicast control contents are configured.
The multicast client sends no IGMP report message.
UNI number 1 UNI port number
Multicast vlan 10 Multicasts VLAN number
Current channel list List of current multicast channels
multicast ip Multicast IP address of multicast channel
status:permit
Multicast control policy
permit: Allows access to the corresponding multicast channel
(without time limit).
preview: Allows previewing the corresponding multicast
channel (with time limit)
preview times:16
This is the sixteenth time the corresponding multicast channel
has been previewed.
preview remain time:144s
The channel can be previewed for 144 more seconds before the
preview ends.
To Next Page
Loading...
